Sprockets that I´ve been making for a while. Sizes vary from 25 to 31 tooth. Full guards can be fitted on the 25t and 27t sizes.
.
Sprockets are made of 7075 T6 aluminum, the best stuff there is for that purpose. Other than sprockets I´ve been doing bash rings, chainguides, custom rear axles and other small stuff.
If the demand is adequate, I might make a small batch of titanium sprockets. However, the price will go up for those, since the higher price of titanium.
Check my site out and give a shout if you´re interested. Feedback and suggestions are always welcome as well. Syndicate Bikes
My friend Jason Moulding figured out that you can put an Odessy one piece driver, all the way down to 9 tooth, on most generic (Woodman,Specialised, Novara, etc.) single speed, disk hubs, by just swapping out the bearings and appropriate spacers. He runs the tightest, lightest drivetrain that I've ever seen with a 9 tooth rear and an 18 tooth, nano-drive sprocket. Personally, it's hard to find 180mm nano cranks, so I run an 11-22 on 180 Profile cranks.
Sprockets are made of 7075 T6 aluminum, the best stuff there is for that purpose. Other than sprockets I´ve been doing bash rings, chainguides, custom rear axles and other small stuff.
If the demand is adequate, I might make a small batch of titanium sprockets. However, the price will go up for those, since the higher price of titanium.
Check my site out and give a shout if you´re interested. Feedback and suggestions are always welcome as well. Syndicate Bikes
Post a reply to: DIY and Customized Thread